PTRobotics

Categorias

Laboratório de tecnologias DIY Algumas das nossas marcas!

Arduino Mega ADK

Arduino Mega ADK

 

The ADK is based on the Mega 2560.

Similar to the Mega 2560 and Uno, it features an Atmega8U2 programmed as a USB-to-serial converter.

For information on using the board with the Android OS, see Google's ADK documentation.

Mais detalhes


66,42 € c/ IVA
54,00 € s/ IVA

PTR000845


Arduino Mega ADK

The Arduino ADK is a microcontroller board based on the ATmega2560 (datasheet). It has a USB host interface to connect with Android based phones, based on the MAX3421e IC. It has 54 digital input/output pins (of which 14 can be used as PWM outputs), 16 analog inputs, 4 UARTs (hardware serial ports), a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button.

The ADK is based on the Mega 2560.

Similar to the Mega 2560 and Uno, it features an Atmega8U2 programmed as a USB-to-serial converter.

For information on using the board with the Android OS, see Google's ADK documentation.

Power

The Arduino ADK can be powered via the USB connection or with an external power supply. The power source is selected automatically.

External (non-USB) power can come either from an AC-to-DC adapter (wall-wart) or battery. The adapter can be connected by plugging a 2.1mm center-positive plug into the board's power jack. Leads from a battery can be inserted in the Gnd and Vin pin headers of the POWER connector.

NB: Because the ADK is a USB Host, the phone will attempt to draw power from it when it needs to charge. When the ADK is powered over USB, 500mA total is available for the phone and board.The external power regulator can supply up to 1500mA. 750mA is available for the phone and ADK board. An additional 750mA is allocated for any actuators and sensors attached to the board. A power supply must be capable of providing 1.5A to use this much current.

The board can operate on an external supply of 5.5 to 16 volts. If supplied with less than 7V, however, the 5V pin may supply less than five volts and the board may be unstable. If using more than 12V, the voltage regulator may overheat and damage the board. The recommended range is 7 to 12 volts.

USB Overcurrent Protection

The Arduino ADK has a resettable polyfuse that protects your computer's USB ports from shorts and overcurrent. Although most computers provide their own internal protection, the fuse provides an extra layer of protection. If more than 500 mA is applied to the USB port, the fuse will automatically break the connection until the short or overload is removed.

 

Schematic, Reference Design & Pin Mapping

EAGLE files: Arduino_ADK-Mega_2560-Rev2-reference-design.zip

Schematic: Arduino ADK_Mega_2560-schematic.pdf

Pin Mapping: PinMap2560 page

Carrinho  

(vazio)

Pesquisa